Fitting instructions for Chord Co screw type speaker plugs:

1. Most Chord Co speaker cables have an outer jacket that surrounds the insulated conductors. If you are fitting these plugs to a Chord speaker cable remove approximately 150 mm (6 inches) of the outer jacket from the end of the cable.

2. Strip the end of each cable conductor so that approximately 6 mm (1/4 inch) of bare wire is exposed

3. Push a banana plug onto the end of each conductor and crimp the end of each plug onto the conductor insulation.

4. Tighten screw securely onto conductor

5. Fit heatshrink so that it just covers the threaded section on each plug (ensure the right colour is fitted to each plug, red for positive +, black for negative -)

6. The heatshrink has been designed to work at a low temperature and can be shrunk to fit with a hair dryer. The heatshrink will seal each connection and prevent the screw from becoming loose.